Sony Charger for the EX1
Sony Charger for the EX1 Autopsy
Took a X-Ray of the Sony charger, I wanted to change out the dc power cord. I was looking for extra screws, that might of been holding it together. Found none except 2. There are plastic sort of clips holding it together, used a small knife to get under the lip on the seam, then used my fingers to pry open the rest of the case. Just 2 screws under the label, Use a small flat head to wedge into the screw and a center post in the screw to turn, anti tamper screw.
Yes, I like to take things apart to see how they work or don’t work.
Monday, January 21, 2008
Radio Shack Plug, Part # 273-1707 “Adaptaplug” “D” 5.5mmO.D.x3.3mm I.D.
Soldered and heat shrink tubing on new cable.
New cable soldered on to board
Holes where screws go. Under label removed, but use Xacto knife to cut out label to gain access to screws, no need to remove entire label.
Clips
Switch must be in same position as top slider to reassemble case
Make sure all those XLR’s are wired up to the correct pins with the correct polarity.Test with continuity tester , then test with power-on battery and power supply, before connecting to the camera!
DISCLAIMER: THIS MAY VOID YOUR WARRANTY.
Velcro- for extra strain relief
Modular plug and power
Powered-up Anton Bauer
Female
Female XLR 4 pin
Male
Radio Shack Plug has yelllow end on it, fits perfectly. Center is positive!
Anton Bauer 12 volt Hytron battery.
Sony power cord for charger
New Neutric Cable
My knife got away from me, be careful!
Comments Widget